Engine Parts - Solenoid 3035738

Solenoid 3035738 is a fuel shutoff or stop solenoid: on the controller signal it cuts the diesel supply and stops the engine.

Its two failure modes give opposite symptoms: if it does not open, the engine cranks and will not fire; if it does not close, the engine will not stop on the key and the valve has to be closed by hand. Both are easily mistaken for a pump fault.

Specifications and compatibility

Voltage (V)

24 VDC

How to verify before ordering

• Match reference, coil voltage (12 V or 24 V) and mounting type (threaded or flange).
• Check whether the solenoid is two- or three-wire: three-wire units carry a hold-in coil and will not accept a two-wire replacement.
• Inspect plunger and return spring in the shutoff mechanism: a bent plunger destroys a new solenoid within a few cycles.

Frequently asked questions

The engine will not stop on the key. Is it the solenoid?

Often, but confirm the signal first: if no voltage reaches the connector when you switch off, the fault is in the controller or the wiring, not the solenoid.

Can I run with the solenoid bridged?

Only as a test and for minutes: bridged, the engine cannot be stopped on the key. Never leave it that way on a set in service.

Related parts

• SELENOIDE 3054610
• SELENOIDE 3017993
• SELENOIDE 437-2617/HWS3072829
• SELENOIDE D59-105-10
• SELENOIDE D59-105-01

See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.