Diode bridge XT-1-40F7A is an auxiliary electrical part: part of the set wiring, protection or indication.
Before replacing, measure continuity and voltage under load. A terminal that shows continuity at no load can drop completely once current flows, and that is the case that wastes the most time.
Specifications and compatibility
- Dimensions
- 30 x 10 x 30 cm
- Weight
- 3.50 kg
How to verify before ordering
- Match voltage, current and conductor cross-section to what the circuit demands.
- Check the connection type (screw, spring, crimp) and terminal gauge.
- Confirm the IP rating if the part sits in an exposed area of the panel.
Frequently asked questions
Why does a terminal get hot?
Contact resistance: too little clamping area or a bad crimp. The heat oxidises the joint and worsens it until the circuit opens.
Can I fit a relay with a higher amp rating?
You can, and it is often good practice, provided coil voltage and contact arrangement match. Never fit one with a lower rating.
Related parts
- DIODERA XT-1-25F10A REDONDO
- TERMINAL COBRE ESTAÑADO 250MCM 185-14
- CONECTOR RELE 4RA003437-09
- CONTACTOR RMSCSH CJ20-63
- TERMINALES DE COBRE DL-185MM
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Weight | 3,50 kg |
| Dimensions | 30 x 10 x 30 cm |
| Spare Parts | |
|---|---|
| Generator Parts | Rectifier kit |
Su snippet dinámico se mostrará aquí...
Este mensaje se muestra ya que no brindó ni un filtro ni una plantilla para usar.
