Selector switch LA38-11X2 is an auxiliary electrical part: part of the set wiring, protection or indication.
Before replacing, measure continuity and voltage under load. A terminal that shows continuity at no load can drop completely once current flows, and that is the case that wastes the most time.
Specifications and compatibility
- Model
- LA38 - 11X2
- Type
- SELECTOR
How to verify before ordering
- Match voltage, current and conductor cross-section to what the circuit demands.
- Check the connection type (screw, spring, crimp) and terminal gauge.
- Confirm the IP rating if the part sits in an exposed area of the panel.
- The reference shown on this listing is LA38 - 11X2; cross-check it against the one stamped on the removed part.
Frequently asked questions
Why does a terminal get hot?
Contact resistance: too little clamping area or a bad crimp. The heat oxidises the joint and worsens it until the circuit opens.
Can I fit a relay with a higher amp rating?
You can, and it is often good practice, provided coil voltage and contact arrangement match. Never fit one with a lower rating.
Related parts
- BOTÓN SELECTOR LA38-20X3
- BOTÓN SELECTOR LA38-20X/33
- BOTÓN SELECTOR LA38-11X22
- BOTÓN SELECTOR LA39-11X2/203
- BOTÓN SELECTOR LA39-20X3-20X3/203
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Type | Selector |
| Model | LA38 - 11X2 |
| Electrical power | |
|---|---|
| Electrical Parts | Other |
Su snippet dinámico se mostrará aquí...
Este mensaje se muestra ya que no brindó ni un filtro ni una plantilla para usar.
